Every moisture problem has a different source. We identify yours specifically before we quote anything — then we deploy the right system, not the most expensive one.
💧
Sub-Slab Interior Drainage Installation
Interior drain tile systems collect groundwater at the footing level before it enters your living space. We saw-cut the slab perimeter, excavate to the footing, install gravel-bed perforated pipe, and tie it into a sump system with battery backup — so you stay dry even during power outages.
Our sub-slab drainage systems use schedule 40 perforated PVC pipe in a stone bed, designed to handle high-volume water tables.
📞 Get a Free Drainage Quote →
🏗️
Exterior Foundation Waterproofing & Membrane Application
Exterior waterproofing is the most comprehensive solution available — stopping water before it contacts your foundation wall. We excavate to the footing, apply a rubberized polymer membrane to the exterior foundation face, install dimple-mat drainage board, and backfill with clean crushed stone to redirect surface water away from the structure.
We use SilkOate, UMARK, and other commercial-grade membrane systems — not the paint-on damp-proofing that deteriorates within a few years.
📞 Schedule an Exterior Assessment →
🔧
Poured-Wall Crack Injection & Block Wall Repointing
Poured concrete foundation cracks are repaired from the interior using high-pressure polyurethane or epoxy injection — the appropriate chemistry depends on whether the crack is actively leaking or dry. Polyurethane foam expands into wet, actively leaking cracks and cures flexible, accommodating minor future movement. Epoxy injection is used in dry cracks where structural bond restoration is the goal.
For concrete block foundation walls showing horizontal cracking or inward bowing, we pair crack repair with carbon fiber reinforcement straps anchored at the floor and rim joist.
📞 Get a Crack Injection Estimate →
🌿
Full Crawl Space Waterproofing & Drainage Installation
We install a minimum 20-mil reinforced poly vapor barrier over the entire crawl space floor and seal it up the walls to the sill plate — then seal all vents, install a conditioned air supply or dedicated crawl space dehumidifier, and spec a sump system if groundwater is present.
Encapsulation turns your crawl space from an uncontrolled dirt floor into a semi-conditioned space.
📞 Schedule a Crawl Space Inspection →
⚙️
Primary & Backup Sump Pump Systems for Iola Homes
The sump pit itself matters as much as the pump. We construct 18-inch diameter pits with a gravel bed at the base for proper water collection, sealed lids to prevent vapor and radon entry, and a discharge line that terminates a minimum of 10 feet from the foundation at a positive-grade daylight point.
For finished basements and properties with high groundwater, we recommend a dual-pump system: a primary submersible at normal operating level and a pedestal backup set two inches higher.
📞 Get a Sump System Quote →
🪟
Egress Window Waterproofing & Well Cover Systems
Basement window wells are one of the most underestimated water entry points in residential waterproofing. When the well drain becomes clogged or the well itself is sized incorrectly for your roof drainage load, water pools against the window frame and enters through the sill, the window-to-frame joint, or the block wall directly adjacent.
Egress window installations create a significant opening in your foundation wall, and sealing the rough opening properly is as important as the window itself.
📞 Book a Window Well Assessment →
